Running Medal Display Rack
Fusion 360
Description
I've collected a couple running medals over the past few years, as I worked on kicking my sedentary lifestyle. I needed a way to show these off in my room, so I put together this project.
Notes & Instructions
Current model assumes the slats are milled from 0.625" stock, and the end caps from 0.75". You can quickly tweak the model so that everything can be machined from 3/4" material.
Only endmill you need is a 1/8" endmill with at least 3/4" of reach. And maybe a surfacing bit if you need to plane down/flatten your stock.
Only endmill you need is a 1/8" endmill with at least 3/4" of reach. And maybe a surfacing bit if you need to plane down/flatten your stock.
Links
Gallery
Project Stats
Downloads
0
Last updated: May 3, 2019