D&D Dice Box

I've put my svg here as well.

pocket cuts
Lid at depth of .45 inch.
Magnet holes are .9 inch deep because the magnets I have are .1 inch thick. You
may have to adjust this if you have different magnets ( or not at all if you want to
install a hinge and hasp.)
Dice pockets, I cut those .4 inch deep. This leaves just enough dice above the
wood so they can be handled.
Pencil pocket is a depth of .2 and should accommodate a mechanical pencil if
desired.
Then profile cut to depth both pieces.

I used a laser engraver to engrave the name on lid and cut piece of felt.