Ima Rottin Tombstone

Made using a 4x8 2" sheet Foamular. This design was done as a 12"x15" piece and cut on a Shapeoko XXL. For bits I used -RC-2243 1" spoilboard to clear out the main recessed in area quicker. - 1/4" Endmill to make recessed area corners sharper (optional step) - RC-1148 60 Degree V bit - 1/4" Endmill to cut shape out. Mine was not long enough to cut 2" , needed to use jigsaw and clean up with flush trim router bit at router table. Paints used - Rustoleum bonding primer (not best choice, eats in to material but also gives weathered look) - Rustoleum chalked aged gray ( was only gray paint store had, does provide nice contrast to primer though)