Rocket Kitchen Tower for 4x4

Cut stars on first side, and then flip the wood along the Y axis to cut out the rocket. If using a 4x4 piece of plywood, this will put the stars in the correct position on the outside of the rocket. I set my width for the platform at 15", so you need to cut a 12x15.5" piece of wood as the pockets are .25". Cut another piece of wood at 4x15.5" for the step. In addition, I used two 2.5x15" pieces with pocket holes to give support at the top on each side, and one 2.5x15" at the bottom opposite of the step for extra support. If you need help, please reach out on the Carbide3D forums and I will assist as much as I can. https://community.carbide3d.com/u/StreetRN/